Euler Connect
The printer you have is all the hardware you need
Euler Connect sends each layer image to Euler as your printer saves it. There is no hardware to fit, and it never touches the printer.
The camera is already there.
Most metal powder-bed printers take a recoat and an exposure image of every layer.
So is the PC.
Euler Connect runs on any machine with access to the images, and sends each one the moment it is saved. Setting it up takes about five minutes.
Checked as soon as it arrives.
The image is analyzed and the layer gets a status within seconds of being saved.
Beside the printer
Point it at the build folder
Show Euler Connect where your printer saves its images. That is the whole setup. Euler Connect only reads those images, and never writes to the printer or changes a parameter.
Each image is sent as it is saved.
Both images of a layer are on their way to Euler immediately after the printer saves them.
Or upload a finished build.
Drop a build folder into the browser and Euler shows you a preview before it starts.
Connection health
See the connection, not only the printer
A machine that quietly stops sending layers is worse than one that is clearly offline. Euler tells you when a connection drops, and when it is back.
Layers wait when the network drops.
Nothing is lost. They are sent as soon as the connection is back.
- SLM 280 - 316LLast layer 12 seconds agoOnline
- EOS M 290 - Ti64Last layer a minute agoOnline
- EOS M 400-4 - AlSi10MgLast layer at 14:02Offline
- RenAM 500Q - Ti64No build runningOnline
Every connection, and its last layer.
Quickly verify printers are uploading their layers, and when the last one arrived.
No layers received since 14:02 yesterday. Heat sink HS-9 was at layer 2,210.
A notice when one goes offline.
So you hear about it from Euler, not from a gap in the data.
Supported printers
Already works with your printer
Supporting 38 models from 15 manufacturers, with nothing to change on the machine. If yours is missing, submit a request to add support for your machine.
Documentation
In the docs
Every screen and every step, written for operators and process engineers.
More of the platform
- Live monitoringAlerts, device status and shop-floor dashboards.
- Print viewerEvery layer, every defect, in 2D and 3D.
- Quality & reportsBuild reports, outlier analysis and sharing.
- Integrations & AIAPI, webhooks, Slack, Teams, Claude and ChatGPT.
- Deployment & securityCloud, on-prem, air-gapped or AWS GovCloud.
Ready to try it on your next build?
Free to start, with the data you already have. Connect a printer or upload a finished build.